Datcon DT9100 I4, Руководство по эксплуатации

Страница: 22 / 64

DT9100 I4
Connecting as “middle”
device •
The DT9100 I4 is situated in the „middle” of the current
loop. In this case one cable comes from the signal source
and another cable goes to the next unit(s).
The following figure shows the connection:
Wiring plan, connecting
into the curren loop
(synchrinising input)
(see also “Application
example”)
Be careful the polarity of
the cables
1. Push the cable-end until it possible into the terminal
assembly. By pushing the wire in, the self-closing
connection is being established.
2. Check it by pulling it outwards slightly.
Checking the
connections Check if the cables are connected properly (have you
connected all the cables, have you connected to the right
place, do not the cable-ends touch each other).
22
20180905-V120180905-V1