Datcon DT1010 Series, Руководство по эксплуатации

Страница: 17 / 40

DT1010 xx xx
20180403-V1
17
7. Setting-up
7.1. First steps
Necessary tools
For setting-up you need:
• mini USB B (5 pin)-USB A cable
• USB driver install program
• DT1010_DT1310 v2013-09-18 - 2015-03-25.exe
configuration software
• PC
Install the virtual COM
port diver
You have to install once the virtual COM driver before use
the configuration program first. This driver provides the USB
port interface as a simple serial port for the configuration
program. The driver is located in folder ‘DT1010\USB
Driver’. Install this driver.
Software
Easy to use DT1010_DT1310 v2013-09-18 - 2015-03-
25.exe configuration software (free of charge). Simple copy
it into an optional folder, click on the “Start” button and you
can configure the instrument.
Setting-up
1. Connect the instrument with the USB cable to the PC
USB port and put it under supply voltage.
2. Start the configuration program.
3. Select the appropriate serial port.
4. Click on the „Open Serial Port” button.
5. st. (red) indicator gives light, signing that the instrument is
configuration mode.
6. power (green) indicator signs with a short flash the
successful communication between the program and the
instrument.
7. Use the configuration software as is written on the
following pages.
8. At the end of the settings click on the “Download settings”
button, the new settings are written into the instrument.
9. Click on the „Close Serial Port” button for finishing the
configuration procedure and disconnect the USB cable.