Datavideo RMC-260, Инструкция по эксплуатации

Страница: 16 / 34

16
Wipe Effects
This sub-option allows the user to select the desired Wipe Transition Effect and configure the wipe’s
border softness and width.
• Wipe – Wipe Effect Selection.
•
Soft
– A low value results in a solid edge border and a high value gives a soft diffused border.
•
Width – A low value results in a thin border and a high value gives a wide border.
Border
After selecting this sub-option, the user will then be allowed to fine-tune the border color by adjusting
the Luma, Saturation and Hue values, i.e. Luma, Sat and Hue.
Position
Position allows the user to adjust the centre position of some wipes (e.g Circle & Elipse). X represents
the horizontal position and Y represents the vertical position.
X Y
Positive value: position the wipe centre to the right
Negative value: position the wipe centre to the left
Zero value: Position the wipe centre at the screen
centre
Positive value: move the wipe centre up
Negative value: move the wipe centre down
Zero value: Position the wipe centre at the
screen centre
Matte
The user can configure the Matte Luma, Saturation and Hue under this sub-option.
4.2 Keyer
In this option, the user is able to configure four keyers, which are Key 1 , Key 2 , DSK 1 and DSK 2 .
Advanced Mode = Basic Mode
Start Keyer Key 1
Keyer
Chroma
Keyer Ctrl
Chroma P-in-P
Priority
Bot
P-in-P Lift 0% Gain 1.0 Opac 100%
P-in-P Lite Key Source Input 1 Fill Input 3
Inputs
Outputs Mask Left 0% Right 0%
Stills
Top
0%
Bot
0%
User Mems
Setup
Keyer Control
There are three keying modes available:
Linear
,
Luma
, and
Chroma
.
After the keying mode is chosen, select
Self
if only one source is enabled for the keyer, which is
Key
source and select Split if two sources are enabled for the keyer, which are Key and Fill sources. You may
also select P-in-P or P-in-P Lite to apply the keying effect to the P-in-P window.
Please note:
If Luma is selected, fine tune the Luma Keyer parameters (Lift, Gain and Opac) in the Keyer option.