Datavideo MCU-400, Инструкция по эксплуатации

Страница: 14 / 40

14
EXP. Exposure Modes Selection Toggle Switch
This toggle switch allows users to select three exposure
modes including Auto Exposure, Exposure Lock and
Manual Exposure.
The toggle switch controls the position of the LED signal
on the left side. The initial position of the toggle switch is
located at the Exposure Lock.

Pull the toggle switch up for one time and then the A
(Auto Exposure) will be selected. When the LED is
shown as A for the first time, the LCD on the front
panel of the MCU-400 will show “Matrix Metering”.
If users pull the toggle switch up for one time, the
LCD will switch to “Center-Weighted Metering”. If
users keep pulling the toggle switch up, the exposure
mode will be switched back and forth between
“Matrix Metering” and “Center-weighted Metering”.

No matter which mode is set for the current
exposure mode, pull down the toggle switch will set
the exposure mode as “Exposure Lock”.

If the MCU-400 is set as “Exposure Lock”, pull down
the toggle switch will set the exposure mode as M,
which is the “Manual Exposure”.
HDR Mode Selection Toggle Switch
This toggle switch allows users to select three HDR modes
including HDR-High, HDR-Middle and HDR-Low.
The toggle switch controls the position of the LED signal
on the left side. The initial position of the toggle switch is
located at the M (HDR-M)

If the toggle switch is located at M, pull the toggle
switch up can set the HDR mode to H (HDR-High).

If the toggle switch is located at M, pull the toggle
switch down can set the HDR mode to L (HDR-Low).

If the toggle switch is located at L, pull down the
toggle switch once will be HDR OFF and then the
HDR function will be turned off. Moreover, all of the
three LED will be turned off, too.