Datavideo MCU-400, Инструкция по эксплуатации

Страница: 11 / 40

11
3.2 Front View
Power Switch
Used to turn on or turn off the power of the MCU-400.
Camera Selection Buttons
Please press those buttons to select the camera that you
want to control.
User X Related Button Set
This button set allows users to save preset parameters to
be 2 self-defined parameters “USER1” and “USER2”. These
two self-defined parameters can be saved back to the BC-
100 camera. Moreover, this button set allows users to
save the USER1 and USER2 settings in the BC-100 to the
MCU-400.
USER1 & USER2
After pressing the “USER1 or USER2 button, the current
parameters of the MCU-400 can be saved back to the
USER1 and USER2 of the BC-100. For detailed operation
steps of the USER1 and USER2, please refer to related
sections in the Chapter 4 “The Operation of the Front
Panel Buttons”.
SAVE
After long-pressing the SAVE button for 3 seconds, the
SAVE button will be flickering in red. After the parameters
that are saved in the BC-100 are saved to the MCU-400
successfully, the SAVE button will be lit in white.
Note: There is one set of USER x parameter only that can
be saved in the MCU-400. If users save more than one
User x into the MCU-400, the previous-saved USER x will
be replaced.
LOAD
After pressing the LOAD button, the USER 1 or USER 2
parameter that are saved in the BC-100 will be loaded