Datasat AP25, Инструкция по установке и эксплуатации

Страница: 103 / 170

AP25 Installation and Operating Guide Page 103
AP25 Installation & Operating Guide Document # 9301H79500 Ver. 1.00
Example: The Fire Alert event programmed to occur when GPI-6 goes low.
Once a Fire Alert event is programmed it will be seen in the Events screen. From here you
can edit or delete the event.
Once the Fire Alert Mode is activated, the AP25 must be restarted from the rear panel power
switch to reactivate normal operation. If the Fire Alert Mode pop up reappears after the
restart, then GPI-6 must still be low. When GPI-6 goes high and the AP25 is restarted from
the rear power switch, the AP25 should reactivate to normal operation.
4.5.1.2
Delete Event
To delete an existing event, highlight the event on the list and select Delete Event.
4.5.1.3
Edit Event
To edit an existing event, highlight the event on the list and select Edit Event. This will bring up the
Automation Edit Event screen. Editing choices are the same as those described above in 4.5.1.1 Add
New Event.