Datas Technology D-100 Series, Руководство по установке

Страница: 32 / 42

Installation
This section provides information on:
Operating environment
Rack, wall, & tabletop installation
Connecting sensors
Replacing batteries
Parts Required
Phillips DB9 F/F null Dumb terminal or PC
Screwdriver modem cable w/DB9 serial port
Operating Environment
Before you install the D-100 Node be sure that your operating environment meets the physical
requirements of the equipment.
Operating Temperature: 32º – 122º Fahrenheit (0º – 50º C)
Humidity: 5 – 90 %RH, non-condensing
Power: 120VAC 60 Hz outlet within 6'
Rack Requirements: Standard 19' equipment rack with supplied mounting bracket
hardware. Requires 1.0 EIA rack mount space.
Tabletop requirements: Flat area which can support an enclosure 10" wide by 8" deep by
2" high.
Battery Replacement
The D-100 Node uses (6) C-size Nickel-Cadmium rechargeable batteries (included) for backup
power in the event that main power fails. The unit will constantly recharge the batteries whenever
the power switch is turned on and the unit is plugged into a power supply.
Replacing Batteries
When replacing batteries, be sure to use good quality batteries that are rated for at least 2000 mAhr
capacity. Batteries of lesser capacity will greatly reduce battery backup time.
To install the batteries, first slide the power switch to the OFF position and disconnect the power
adapter. Next, remove the top cover of the unit by removing the six screws using a small flat-head
screwdriver. Insert the batteries into the battery holder following the polarity markings indicated on
the battery holder. After installing the batteries reattach the top cover.
NOTE: Use Nickel-Cadmium rechargeable batteries.
Installation Manual
32