iBootBar
Page 12
ibootbar_v1.2x
Command Line Interface
The Command Line Interface follows a
set/get
syntax similar to SNMP.
iBBar configuration can be performed from the CLI or by using the Control and Setup Utility ( CSU.exe). The CLI can be
accessed via Telnet Client, Serial Port and Dial-up Modem, using a Terminal client. Below is a listing of all interface
commands and syntax.
Device Commands
Description
get device name
set device name <name>
Each iBootBar can have a name assigned. 20
characters Max, no spaces.
get current
Returns the current draw for each Main in
Amperes
set password <oldpass> <newpass> <confirm>
Sets the password for the current user
get cycle
set cycle <n>
The cycle time is the length of the reboot or
power on. In seconds 1 - 99
get delay
set delay <n>
The delay time is the pause between power up of
each outlet when multiple outlets are powered
on. 0 - 99
logout
Ends the session
The following commands require administrative rights
get current alarm
set main <a/b> highalarm <nn.n>
set main <a/b> lowalarm <nn.n>
High and Low alarms are used to monitor current
conditions and send an alert by email or SNMP
when the high or low thresholds are exceeded.
From 0.0 to 15.0 (20.0 in 20 amp units) in 0.0
amp increments. Main A and Main B are set
separately, but displayed together with the get
command.
get console
Display current console configuration
ß
set console timeout <30-3600/disable>
Console can be set to automatically logout with
no activity for 30 seconds to 1 hr in seconds, or
disabled.
ß
set console baudrate <baud>
2400, 4800, 9600, 19200, 38400, 57600,
115200
get modem
Returns all modem parameters
set modem countrycode<countrycode>
Set the country code. See Appendix for a list of
country codes and approvals.
set factory defaults
Reset all parameters, including IP address and
passwords to factory defaults. Can only be
executed from the serial port. Confirmation
required.
reboot
Reboots the iBootBar itself. Use after firmware
upload, changing IP or SNMP Manager settings.
The status of the outlets will NOT be effected
