Dataprobe iBoot-DC, Руководство пользователя

Страница: 23 / 28

iboot-dc_v181024e
iBoot-DC Page 23
Autoping Commands
These commands require a reboot before they will take effect. These
commands are available to the administrator only.
get autoping
This command returns all of the AutoPing settings as shown
below.
AutoPing 1 AutoPing 2
Address: 192.168.233.254 iboot.co
Frequency: 10 10
Fail Count: 3 3
Status: OK OK
Trig Count: 0 0
-------------------------------
Mode: Single
Action: Cycle Once
Wait: 2
Restart: 0
set autoping <1 | 2> address
<dotted decimal or name> This command is used to set the address of AutoPing 1 or
AutoPing 2. Use IP Address or domain name.
set autoping <1 | 2> frequency
<1-999> This command is used to set the frequency (how often the
iBoot-DC sends the ping) for each of the AutoPings. 10
set autoping <1 | 2> failcount
<1-999>
This command is used to set the number of consecutive
failures the AutoPings must detect before the AutoPing
considers the pinged device to be failed. 3
set autoping mode <single |
and | or>
Sets single AutoPing or two AutoPing relationship And or Or. Single
set autoping action <none | on-
latch | on-follow | off-latch | off-
follow | cycle> This command is used to set the action that the iBoot-DC will
perform when the autoping triggers. None
set autoping cycle <0-999> This command sets the maximum number of power cycles
when the AutoPing triggers. 0 = Unlimited 1
set autoping wait <1-999> This command sets the time, in seconds for the device to
respond to a ping. 2
set autoping restart <1-999> After an autoping has been triggered, this command sets the
time, in seconds before the autoping will resume. (added
delay after cycle complete) 0
User Commands These commands are only available to the administrator.
set user account <yes | no> This command sets whether or not a user account is used. If
<n> only the administrator account is active n
set login required <yes | no> This command sets whether or not a login is required for user
level operation. A login is always required for admin
functions. y
set password <user | admin>
<old> <new> <repeat> This command is used to set the password of either the user
or administrator. user
admin