Datapath Q Series, Инструкция по эксплуатации

Страница: 26 / 104

Operation Q-Series
26
15. Loosen the Coarse Elevation Lock.
NOTE
Always hold the Q-Series by the handle when loosening the Coarse Elevation Lock
to avoid it tipping over.
16. Roughly point Q-Series in elevation by moving the reflector up or down by handle . Crosshairs on
the GUI represent target . Move reflector until circle is at roughly same height as crosshairs and
the Elevation value on the left (target) corresponds with the value in the right (elevation value
from inclinometer) The Green arrows will tell which direction to move. Lock reflector in place by
tightening Coarse Elevation Lock when coarse elevation is set..
17. Loosen the Coarse Azimuth Lock.
18. Roughly point the Q - Series in azimuth by moving the reflector sideways . The crosshairs on the
GUI represent the target . Move the reflector until the circle is at roughly the same position as the
cross - hairs and the value on the bottom (target) corresponds with the value on the top (value
from GNSS/compass). Lock the reflector in place by tightening the Coarse Azimuth Lock when
coarse azimuth is set.
Press the right navigation arrow to proceed.