DataOn Storage CiB-9224 V12, Техническое руководство

Страница: 12 / 36

CiB ‐ 9224 V12 User Manual
8
Canadian Notice (Avis Canadien) Class
A Equipment
Power Cords
The power cord set included in the system meets the requirements for use in the country where the
system was purchased. If this system is to be used in another country, purchase a power cord that is
approved for use in that country.
The power cord must be rated for the product and for the voltage and current marked on the product's
electrical ratings label. The voltage and current rating of the cord should be greater than the voltage and
current rating marked on the product. In addition, the cross-sectional area of the wires must be a
minimum of 1.00mm² or 18AWG, and the length of the cords must be between 1.8m (6 feet) and 3.6m
(12 feet). If you have questions about the type of power cord to use, contact an authorized service
provider.
Route power cords so that they will not be walked on or pinched by items placed upon or against
them. Pay particular attention to the plug, electrical outlet, and the point where the cords exit from the
product.
Rack Mount Instructions
The following or similar rack-mount instructions are included with the installation instructions:
 Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating
ambient temperature of the rack environment may be greater than room ambient. Therefore,
consideration should be given to installing the equipment in an environment compatible with the
maximum ambient temperature (Tma) specified by the manufacturer.
 Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
 System placement – System must be place on a leveled surface.
 Circuit Overloading – To avoid power supply overload, make sure main power source is adequate
to accommodate all system.