Datalogic Quickscan QD2200, Руководство по продукции

Страница: 36 / 235

ENTER/EXIT PROGRAMMING MODE USB-COM INTERFACES
6
QUICKSCAN™ I QD2200
ACK NAK Timeout Value
This option specifies the amount of time the scanner waits for an ACK character
from the host following label transmission. The selectable timeout range is 200
milliseconds to 15,000ms (15 seconds) in 200ms increments. A selection of 0
disables the timeout. See
"
ACK NAK Timeout Value" on page 151
for more detailed
programming instructions.
ACK NAK Retry Count
This feature specifies the number of times the scanner retries a label transmis -
sion due to a retry condition. The selectable range is from 1 to 254 retries. A
selection of 0 disables the count, and a selection of 255 specifies unlimited
retries. See "
ACK NAK Retry Count" on page 152
for more detailed programming
instructions.
Select ACK NAK Timeout Value Setting
$CR2AT
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig -
its from the Alphanumeric characters in Appendix D
representing your desired character(s). End by scan -
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL

01 ACK NAK Timeout value is 200ms
Select ACK NAK Retry Count Setting
$CR2AR
To configure this feature, scan the ENTER/EXIT bar
code above, then the bar code at left followed by dig -
its from the Alphanumeric characters in Appendix D
representing your desired character(s). End by scan -
ning the ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again
at the beginning.
CANCEL

003 = 3 Retries