Datalogic PowerScan Series, Руководство по продукции

Страница: 308 / 411

ENTER/EXIT PROGRAMMING MODE WIRELESS FEATURES
292
POWERSCAN™ PD/PM/PBT9600
RF ADDRESS STAMPING
These features allow configuration of source radio data inclusion.
Source Radio Address Transmission
Enables/disables the ability of source radio address information to be transmitted to the
host and, if so, at what position with respect to the label data. See
page 339
in “Refer -
ences” for detailed information and examples for setting this feature.
Source Radio Address Delimiter Character
This option specifies the delimiter character to be placed between the label data and
radio address when address stamping is enabled.
NOTE: When included as a prefix, the source-radio ID is displayed after all
label formatting has been applied. The 6 byte hex address is sent as 12
ASCII characters, i.e., an address of 00 06 66 00 1A ED will be sent as
(shown in hex): 30 30 30 36 36 36 30 30 31 41 45 44
$CBTAS00

Source Radio Address Transmission =
Do Not Include
Source Radio Address Transmission = Prefix
$CBTAS01
NOTE: This feature only applies if "
Source Radio Address Transmission" on
page 292
is enabled.
Set Source Radio Address Delimiter Character
$CBTAD
To configure this feature, scan the ENTER/EXIT PRO -
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu -
meric characters in Appendix G, Keypad represent -
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL

Delimiter Character = 00 (no delimiter character)