INITIAL SETUP
13
3
3 INITIAL
SETUP
This procedure allows setting up the reader to operate with the default settings.
Two different procedures are available according to the type of application you are
working with:
−
Lynx™ BT paired to the OM-1000 BT (follow procedure in par. 3.2);
−
Lynx™ BT communicating with a Bluetooth
®
device (follow procedure in
par. 3.3).
Whenever you need to change the default values refer to par. 4.2.
3.1 OM-1000 BT INTERFACE CABLE CONNECTIONS
The OM-1000™ can be connected to a Host by means of an RS232, Wedge or USB
cable which must be simply plugged into the Host connector, visible on the rear panel
of the cradle.
To disconnect the cable, insert a paper clip or other similar objects into the hole
corresponding to the Host connector on the body of the cradle. Push down on the clip
while unplugging the cable. Refer to the following figure:
Multi-standard interface
RS232, WEDGE, or USB
to Host
Power
Figure 4 – Connecting/Disconnecting the Cable
Содержание lynx bt
