Datalogic DS6400, Справочное руководство

Страница: 14 / 159

xiv
GUIDE TO INSTALLATION
POINT-TO-POINT INSTALLATION
The following can be used as a checklist to verify all the necessary steps to complete
installation of the DS6400 scanner.
1)
Read all information in the section “Compliance” at the beginning of this manual.
2) Correctly mount the scanner using the bracket provided according to the information in
par. 2.2 and position it at the correct reading distance according to your model as shown
in par. 2.3 and par. 9.5.
3) Make electrical connections to your DS6400 scanner by:
a) Connecting the DS6400 scanner to the CBX100/CBX500 by means of one of the
CAB-Sxx (or CAB-F0x depending on the model) cables provided as an accessory
(see par. 1.8).
b) Providing correct and complete system cabling through the CBX100/CBX500
according to the signals necessary for the layout of your application (trigger, inputs,
outputs).
Cabling: Power, Interface, Inputs, Outputs, etc. For further details, see chapter 3
(chapter 4 for custom cabling).
Alternative Layouts: Point-to-Point, Pass Through, RS232 Master/Slave,
Multiplexer. See appendix A for layout references.
4)
Configure the DS6400 scanner by installing and running the Genius™ configuration
program from the CD-ROM provided. See chapter 8 and the Help On-Line for details.
The main steps are:
Select the codes to be read
Set-up the communication parameters
When PackTrack™ is required, set the PS Offset and Position parameters
Define data formatting parameters
NOTE
Fine tuning of the scanner position for barcode reading can be
accomplished by performing a test through the SPY configuration tool in
Genius™.
5) Exit the configuration program and run your application.
The installation is now complete.