
DS2100N REFERENCE MANUAL
6
1
Auto Learn
If you are configuring your scanner using X-PRESS™, you must start with the
Auto Learn
procedure.
1. Enter the
Auto Learn
function by holding the X-PRESS™ push button pressed until the
LEARN LED is on.
2. Release the button to enter the
Auto Learn
function.
Once entered, the reader starts a procedure to automatically detect and recognize
barcodes (by type and length), which are presented to it (*). The laser turns on and the
LEARN LED blinks to indicate the ongoing process.
green
green
yellow
yellow
red
SETUP
LEARN
TEST
READY
GOOD
TRIGGER
COM
STATUS
Figure 6 – X-PRESS™ Interface: Auto Learn Function
The procedure is as follows:
A)
place
the desired barcode on
the scanline.
B)
wait
until the LEARN LED stays
steady on (indicating the reader
has detected the barcode).
C)
repeat
, if needed, the above
two steps to program up to 10
different barcodes (the LEARN
LED returns to the blinking state
for the next code). If more than
one barcode is detected in the
scan line, the Multi Label mode
is enabled (refer to the “2K/4K
Family Software Configuration
Parameter Guide” Help file).
3.
Exit
the process by pressing the X-PRESS™ push button once. The scanner will restart
at the end of the process, and then the detected barcodes are automatically configured in
scanner memory.
NOTE
If the barcode cannot be read because of low contrast or excessive ambient
light, you can perform the AutoSetup function to optimize the optical
parameters. Then you can perform AutoLearn to recognize the barcode
symbology.
NOTE
On exit from Autolearn, the following parameters are forced: Code
Combination = Single Label, Reading Mode = Linear. If necessary, these
parameters can be changed through Genius™.
* In case of Programming Barcodes (refer to the “Setup Procedure Using Programming Barcodes” document in
the product CD).
Содержание DS2100N
