Datalogic DM3610, Справочное руководство, Страница: 48 / 157

TWO-HEAD DIMENSIONING SYSTEM REFERENCE MANUAL
38
3
3.2 INSTALLATION SEQUENCE
NOTE:
Everything should be MECHANICALLY INSTALLED before
performing any ELECTRICAL INSTALLATION . See chapter 2 for mechanical
installation details.
Most DM3610 applications are shipped with the CBX100 connection box and
all the necessary cabling required to electrically install the system. If your
system requires custom-length cables or other special wiring, documentation
specific to these requirements has been provided in your shipment. This
special documentation supersedes any contradictory content in this manual.
NOTE:
To reduce the possibility of damage to the unit, check all cabling
between the DM3610 and other devices for accuracy.
3.2.1 Connecting a DM3610-3100/3200/3300 Singulated, non-touching
To install a two-head dimensioning system, follow this sequence:

Complete mechanical installation (See chapter 2.)

Complete electrical installation.
(See wiring illustrations provided in this chapter.)

Observe all electrical safety requirements outlined in this chapter.

Ground the mounting structure to protective earth (PE) ground.

If used, wire the photoelectric sensor (or other trigger) to the CBX connection box.

Wire the tachometer to the CBX connection box (if used).

Wire serial ports to the CBX connection box if needed.

Connect the dimensioner cabling to the CBX connection box and DC3000 Controller
as required by your application.

Wire the monitor to the CBX connection box.

Connect the power supplies to the equipment.

Connect the power supply to the power source.

Setup / check dimensioning system operations (See chapter 5.)