Datalogic AREX 401, Руководство пользователя

Страница: 42 / 148

TECHNICAL SPECIFICATIONS
34
AREX™ 401
Table 5: X1 - Command Box connector pinout
(*) refers to Lighter™ user's manual “Setting I/O parameters” paragraph to set the signal properties
(**) refers to Lighter™ user's manual
(***) see “Input/Output specifications” on page 41
X1.16 VIN_EXT
Input power
supply
External reference input power supply voltage for PNP output type
configuration:
- NOT CONNECTED or GND: sets all digital outputs to NPN (default)
- 10÷28V DC sets all digital outputs to PNP
X1.17 END
Digital Output
PNP/NPN
configurable
This signal is used to know if the marking process is finished:
- ON at the end of marking process
X1.18 POWER_ON
Digital Output
PNP/NPN
configurable
This signal is used to know if the laser marker is already warmed up:
- ON when the laser is in STAND_BY or READY state
X1.19 GND Ground Ground reference
X1.20 SYSTEM_ALARM
Digital Output
PNP/NPN
configurable
This signal is used to know if the laser marker is in booting up state
or in error state:
- ON during BOOTING UP
- ON in case of system error
X1.21 GND Ground Ground reference
X1.22 ENABLE_OUT
Digital Output
PNP/NPN
configurable
This signal is used to know if the laser marker is ready to emit laser
radiation:
- ON when the laser marker is in READY state
X1.23 SW_READY*
Digital Output
PNP/NPN
configurable
Depending on the configuration this signal can be used in different
ways:
- COMPATIBILITY: ON when a document or a sequence is running in
AUTO MODE** or WORK MODE** independently from the laser
marker state. The signal is ON regardless of whether the laser
marker is ready to start a new marking
- STANDARD: ON when a document or a sequence is running in AUTO
MODE** or WORK MODE** and the laser marker state is READY. The
signal is ON regardless of whether the laser marker is ready to start a
new marking
- READY TO MARK: ON only when a document or a sequence is run-
ning in AUTO MODE** or WORK MODE** and the laser marker state is
READY. The signal is ON only if the laser marker is ready to accept a
new START_MARKING event (loading/spooling already executed)
This signal can also be driven using Lighter™ Script engine
"IoPort.setReady (true)" function
X1.24 GND Ground Ground reference
X1.25 GND Ground Ground reference
PIN SIGNAL TYPE*** DESCRIPTION