DKM-0208 User Manual V-1.0
(26.10.2015)
-9-
The main configuration of the unis is done with jumpers located on back panel.There are
8 jumpers on the unit and the settings are described below.
1-2-3. Jumper:
4. Jumper
5-6-7-8. Jumper:
Filtering Time Setting:
BaudRate Setting:
Modbus Adress Setting:
1
2
3
4
5
6
7
8
1
1
1
2ms 1
9600 baud
8
4
2
1
1
1
0
5ms 0
19200 baud
There are 16(1-16) adresses
1
0
1
10ms
can be defined. For example:
1
0
0
20ms
5(OFF),6(OFF),7(OFF),8(OFF)
0
1
1
50ms
1 + 8 + 4 + 2 + 1 = 16
0
1
0
100ms
5(OFF),6(ON),7(ON),8(OFF)
0
0
1
200ms
1 + 8 + 0 + 0 + 1 = 10
0
0
0
500ms
5(ON),6(ON),7(ON),8(ON)
1 + 0 + 0 + 0 + 0 = 1
Adjusted led colors can be checked by pressing the TEST pushbutton.(If the TEST
pushbutton is pressed again, the unit returns back to normal operation) After that, if the
TEST pushbutton is pressed long (for 3 seconds) first led flashes with the adjusted color.
By pressing RESET pushbutton, signal leds can be selected from up to down, by
pressing HORN pushbutton signal leds can be selected from left to right. The color of the
signal can be adjusted by pressing the TEST pushbutton. After pressing the ACK
pushbutton all leds are seen with the adjusted color.(If the ACK pushbutton is pressed
again, the unit returns back to settings menu) After that, if the ACK pushbutton is
pressed long(for 3 seconds) the unit saves all settings and exist from the menu.
If the HORN pushbutton is pressed, all leds flash green and red in sequence, the internal
buzzer sounds, Horn, Bell and Watchdog Relays turns on and off with a period of one
second. During this test, if the pushbutton pressed long(for 3 seconds) buzzer function
can be disabled/enabled. By pressing the pushbutton again, the unit exists from the test.
4. SETTINGS
4.1 JUMPER SETTINGS
4.2 SIGNAL LED RED/GREEN SETTINGS
4.3 BUZZER SETTINGS
