Datakom D Series, Руководство пользователя

Страница: 82 / 138

D-500L Firmware V-5.8
K35D03-EN - 82 -
Parameter Definition Unit Min Max Factory
Set
Description
Genset Low Frequency
Warning Limit
% F-100 F+100 V-15%
If the genset frequency goes under this
limit when feeding the load, this will
generate a
GENSET LOW
FREQUENCY warning.
Genset Low Frequency
Shutdown Limit
% F-100 F+100 F-20%
If the genset frequency goes under this
limit when feeding the load, this will
generate a
GENSET LOW
FREQUENCY shutdown alarm and the
engine will stop.
Genset High Frequency
Warning Limit
% F-100 F+100 F+15%
If the genset frequency goes over this
limit when feeding the load, this will
generate a
GENSET HIGH
FREQUENCY warning.
Genset High Frequency
Shutdown Limit
% F-100 F+100 F+20%
If the genset frequency goes over this
limit when feeding the load, this will
generate a
GENSET HIGH
FREQUENCY shutdown alarm and the
engine will stop.
Genset Frequency Fail
Timer
sec 0 10 1
If the genset frequency goes outside of
the limits during this timer, a genset
frequency fault will occur.
Low Battery Voltage
Warning Limit
V-DC 5.0 35.0 12.0
If the battery voltage falls below this
limit, this will generate a
LOW
BATTERY warning.
Low Battery Voltage
Shutdown Limit
V-DC 5.0 35.0 9.0
If the battery voltage falls below this
limit, this will generate a
LOW
BATTERY shutdown alarm and the
engine will stop.
High Battery Voltage
Warning Limit
V-DC 5.0 35.0 29.0
f the battery voltage goes over this limit,
this will generate a
HIGH BATTERY
warning.
High Battery Voltage
Shutdown Limit
V-DC 5.0 35.0 30.0
If the battery voltage goes over this
limit, this will generate a
HIGH
BATTERY shutdown alarm and the
engine will stop.
Battery Voltage Fail
Timer
sec 0 10 3
If the battery voltage goes outside of the
limits during this timer, a battery voltage
fault will occur.
Genset Voltage
Unbalance Limit
% 0 100 0.0
If any genset phase voltage differs from
the average more than this limit, it will
generate a Voltage Unbalance fault
condition. The action taken upon fault
condition is programmable.
If this parameter is set to 0.0 then
voltage unbalance is not monitored
Genset Voltage
Unbalance Action
- 0 3 0
0: no action
1: shutdown alarm
2: loaddump alarm
3: warning
16.2. ELECTRICAL PARAMETERS GROUP (continued)