DataExpert MBX8440, Руководство пользователя

Страница: 11 / 44

Chapter 2
Page : 8
Hardware Configuration
2
2-4 Jumper Settings
You can configure hardware options by setting jumper on the mainboard.
See Figure 2-1 for jumper locations.
Set a jumper as follows:
§ Short a jumper by placing the plastic jumper cap over two pins of
the jumper.
§ Open the pins of a jumper by removing the jumper cap.
Note:
When you open the jumper, attach the plastic jumper cap
to one of the pins so you won’t lose it.
Symbols:
For setting 3-pin jumpers, the symbols below are used:
Pins 1 and 2 are Shorted with a jumper cap.
Pins 2 and 3 are Shorted with a jumper cap.
For setting 2-pin jumpers, the following symbols are used:
The jumper is Shorted when the jumper cap is placed over
the two pins of the jumper.
The jumper is Open when the jumper cap is removed from
the jumper.
P3 P2 P1
P3 P2 P1
P2 P1
P2 P1