DataDirect Networks EF4024 FC, Руководство по установке

Страница: 27 / 73

Connecting Hosts
96-30065-001 Rev. A0 DataDirect Networks EF4024 FC RAID System Setup Guide | 27
3. Enable the CLI port for subsequent communication:
❖ Linux users should enter the command syntax provided in Section D.2.2 .
❖ Windows users should locate the downloaded device driver described in
Section
D.2.1 , and follow the instructions provided for proper installation.
4. Start and configure a terminal emulator, such as HyperTerminal or VT-100, using the
display settings in
Table 2 and the connection settings in Table 3 (also, see " Using
HyperTerminal with the CLI on a Microsoft Windows host " following this procedure).
Parameter Value
Connector
COM3 (for example)
1,2
Baud rate 115,200
Data bits 8
Parity None
Stop bits 1
Flow control None
5. In the terminal emulator, connect to controller A.
6. Press Enter to display the CLI prompt (#). The CLI displays the system version, MC
version, and login prompt:
❖ Enter the default user name,
manage
❖ Enter the default password,
!manage
If the default user name or password—or both—have been changed for security
reasons, enter the secure login credentials instead of the defaults shown above.
7. At the prompt, enter the following command to set the values you obtained in step 1.
for each Network port, first for controller A, and then for controller B:
set network-parameters ip
address
netmask
netmask
gateway
gateway
controller [a|b]
where:
❖
❖
address
is the IP address of the controller
netmask
is the subnet mask
Table 2. Terminal Emulator Display Settings
Parameter Value
Terminal emulation mode VT-100 or ANSI (for color support)
Font Terminal
Translations None
Columns 80
Table 3. Terminal Emulator Connection Settings
1. Your server or laptop configuration determines which COM port is
used for Disk Array USB port.
2. Verify the appropriate COM port for use with the CLI.