204.4291.04
30
Command
Description
#
show running-config
Verifying the current configuration.
#
show environment
Verifying the temperature of modules.
#
show
firmware local
Verifying firmware version.
#
show
inventory
Verifying hardware information.
#
show platform
Verifying device modules.
Example of show commands avaliable
5.2.
CONNECTING BY CONSOLE INTERFACE
It is possible to access the CLI by the Console port located at the device front panel. For that, connect a
console cable and run a terminal emulator as Hyper Terminal or similar on your PC. The
terminal software must be set as 9600 8N1.
Check in
Console Interface
chapter for cable assembly and pinout or in
chapter for further recommendations on the cable and console interface.
5.3.
CONNECTING BY MGMT INTERFACE
Alternately, it is possible to access the CLI by the MGMT port also located at the device front panel. The MGMT
port is an Ethernet interface dedicated to manage the device and it is unable to perform
switching
or
routing.
To access the CLI, connect a LAN cable to the MGMT port and set an IP address on the
network adapter of your PC. The default IP address is 192.168.0.25/24. Run a SSH
application on a PC to start a terminal session with the device. Telnet session is not supported at
the current version.
Check in
MGMT Interface
for the lights or in
recommendations on the cable.
