204.4291.04
18
3.3.1.
I
NSERTING THE
F
AN
M
ODULE
The FAN module occupies your respective position localized in the rear of DM4610 chassis and is fixed with
two side screws included with the module.
The process for insertion must follow the steps below.
Step 1
Position fan module guide between DM4610 chassis guide.
Step 2
Make sure that the backplane connectors are aligned for fitting.
Step 3
Push the module until it touches the DM4610 chassis.
Step 4
Tighten the side screws that attach the module to the DM4610 chassis.
3.3.2.
R
EMOVING THE
F
AN
M
ODULE
Follow the step below to remove the fan:
Step 1
•
Loosen the side screws that attach the module to the DM4610 chassis.
Step 2
•
Pull the module until release the backplane connectors.
3.3.3.
C
HECKING
F
AN
O
PERATION
By powering the system, the fans begin to rotate at the maximum speed.
3.3.4.
I
NSTALLING OR
R
EMOVING THE
A
IR
F
ILTER
The air filter fits into the plastic support fixed in the fan module rear, thus all the air captured by the FAN
module from the external environment passes mandatorily through the air filter.
Air Filter specification: 30 to 40 PP1
(Pores Per Inch)
.
The process for insertion must follow the steps below.
Step 1
•
Using a needle-nose pliers or tweezers remove the plastic grid fixing the air filter.
Step 2
•
Remove or replace the air filter
Step 3
•
Position the grid back in place and press to fit.
FAN module without air filter
