204.4291.04
25
4.
INSTALLING AND REMOVING SFP MODULES
This chapter describes how to install and remove SFP modules.
The SFP (Small Form-Factor Pluggable) modules are used in the equipment’s SFP ports, serving as
transceivers between the card and the chosen means of communication (CAT-5 optic fiber or electric).
Whenever some form of work is conducted on the equipment, it is necessary for the
technician implementing the alteration to check beforehand that suitable protection is
present. Grounding (and the use of an antistatic wrist strap) prevents damage to the
equipment and risks to technician's health.
Modules without approval do not guarantee correct operation of the equipment and may
damage interface cards. Contact the technical support team about the risks of using not
approved modules and the possibility of unblocking them.
4.1.
INSTALLING THE SFP MODULES
The SFP installation is conducted as shown on following steps:
Step 1
•
Remove the plastic protector plug of the SFP receptacle.
Step 2
•
Insert the module into the SFP slot of the equipment and pushing it until it is firmly
held. The correct position of the attachment can be seen in following figure.
Inserting a SFP module
Step 3
•
After attaching the module, it is necessary to secure the securing handle as shown
below, as it serves as a lock for the optical cables when these are connected.
Locking the SFP module
