DM4380 – Installation Guide
Hardware DESCRIPTION
204.4336.00 - October/2019
20
Figure 13 – Removing the TERMINAL BLOCK from the PSU 125 DC
Step 2
Locate the power cord shipped with the
PSU 125 DC,
and cut it to
the desired preferred length. If the cable needs to be replaced, it is
important that it have a gauge of
1mm
2
or higher, and that the
conductor colors follow the specifications of the country where it is
installed
.
Step 3
Using the same 1/8" screwdriver (number 0) used above, as shown
below
:
Figure 14 – Installing the cable mounted to the TERMINAL BLOCK
Step 4
Before the cable is powered, screw the connector with the cable
installed on the
PSU 125 DC,
using the same 1/8" screwdriver
(number 0) used above, as shown below
:
Figure 15 – Installing the cable mounted to the TERMINAL BLOCK on the PSU
125 DC
Table 9 – Installing the PSU 125 DC power supply
