Datacom Systems WANswitch W2358DSL, Руководство по оборудованию, Страница: 20 / 36

Daisy-Chain Addressing
IMPORTANT
PRIOR to installing any WAN switch
™
in a daisy-chain , the
address of each individual switch must be set one switch at a
time to perform the daisy-chain address configuration. The
hardware connection to perform this configuration from a
stand-alone computer platform is explained next. After the
hardware connection has been accomplished, the address of
each individual switch must be set one at a time with the
ATTACH
it program as described in the DATACOM switch
SOFTWARE guide .
Connection Instructions
The typical daisy-chain addressing installation described
herein will be for a WAN
switch
™
.
Step 1: Connect the COM1 port of the computer platform to
the
Control
port of the WAN switch
™
using a DRL341-3-3
cable as shown Figure C1 .
Step 2: Connect the Power Supply 5-pin DIN Male connector
into the
Power
port of the WAN switch
™
and then plug the
Power Supply into the external power source wall receptacle.
A green light within the center of the Datacom front panel logo
indicates power is on.
C1
D DA AI IS SY Y- -C CH HA AI IN N