Datacom Systems WANswitch W2358DSL, Руководство по оборудованию, Страница: 12 / 36

4
HARDWARE
I IN NS ST TA AL LL LA AT TI IO ON N
Connection Instructions
(WANic)
The typical installation described herein will be for a
WAN
switch
™
with the Sniffer Technologies two port WAN
RS/V Analyzer running Sniffer
®
Distributed Analysis
Software.
Installation for a single W2358D
SL
is shown in Figure 3
using DRL311-2-4 V.35 Y-Cable to connect to the Wide Area
Networks. Make the W2358D
SL
interconnection between a
DSS Analyzer and individual network links as follows:
NOTE:
The DRL459-3-3 Common Cable will also operate in
an RS232 environment, but a DRL469 Male to Female
adapter is required to be used in conjunction with the
DRL459-3-3 Common Cable. Upon request, the adapter will
be sent out Next Day Air free of charge after calling and
receiving authorization from Datacom Technical Support.
Step 1: Connect the DRL-459-3-3 Common Cable DB60
Male lead to the
MONITOR
port of the DSS Analyzer.
Step 2: Connect the DRL-459-3-3 Common Cable DB15
Female lead labeled “
A
” to the
Common A
port of the
WAN switch
™
.
Step 3: Connect the DRL-459-3-3 Common Cable DB15
Female lead labeled “
B
” to the
Common B
port of the
WAN switch
™
.
Step 3: Connect the DRL341-3-3 Control Y-cable DB9
Male lead labeled “
A
” to the COM 1 port of the DSS
Analyzer.
NOTE:
For single DSS Analyzer installations the DB9 Male
lead labeled “
B
” has been factory tie-wrapped into a 2-inch
coil approximately 8-inches from the common connector so it
can be easily stored above, below, or hang innocuously
behind the DSI switch.
Step 4: Connect the DB9 Female lead of the DRL341-3-3
Control Y-cable to the
Control
port of the WAN switch
™
.
Step 5: Connect network cables to each link port.
Step 6: Connect the Power Supply 5-pin Male DIN connector
into the
POWER
port of the WAN switch
™
and then plug the
Power Supply into the external power source wall receptacle.
A green light within the center of the Datacom front panel
logo indicates power is on.