Data Translation DT3152-LS, Руководство по началу работы

Страница: 45 / 84

Installing and Configuring the Device Driver
35
5
5
5
5
5
5
5
5
5
As Windows 95 (Version 4.00.950 or 4.00.950a) Starts
To install the DT3152-LS Device Driver under version 4.00.950 or
4.00.950a of Windows 95 as it starts, perform the following steps:
1. Start Windows 95.
The New Hardware Found dialog box appears stating that a new PCI
Multimedia Video Device was detected.
2. Click Driver from disk provided by hardware manufacturer ,
then click OK .
The Install From Disk dialog box appears.
Note: You may choose Do not install driver at this point, if you
wish. To install the driver at a later time, see page 36 .
3. Insert Imaging OMNI CD into the CD-ROM drive .
4. Click Browse , browse to x:\DRIVERS\DT3152LS\Win95
(where x is the letter of your CD-ROM drive) , then click
OK
.
5. When the files have been copied, remove the CD-ROM from the
CD-ROM drive.
You are prompted to restart your system.
6. Click Yes to restart the system.
For proper operation, it is very important that you restart Windows 95
when prompted.
7. If a Windows 95 Shutdown dialog box appears, manually close
all open applications on your desktop, then click
OK to continue.
Otherwise, the system restarts.
When the system restarts, a dialog box appears prompting you to
initiate the Configuration Utility.
8.
Click
OK
to initiate the Configuration Utility.
Note that is not necessary to log in to Windows or your network to run
the Configuration Utility.
9. Click OK to begin configuring the DT3152-LS board.