Data Translation DT3145, Руководство по началу работы

Страница: 50 / 60

Chapter 6
42
Table 1: Troubleshooting Problems
Symptom Possible Cause Possible Solution
Board does not
respond. The board is
incorrectly aligned in
a PCI expansion slot. Check that the slot in which your DT3145
board is located is a PCI slot and that the
board is correctly seated in the slot; see
the instructions starting on
page 17 .
The interrupt level is
unacceptable. An interrupt conflict exists in your system.
The most common interrupt conflict
occurs with a PCI device and a device that
is plugged into the ISA bus. To resolve
this problem, change the interrupt setting
(usually by changing a jumper) on the ISA
device.
An interrupt conflict can also occur if a PCI
device was not designed to share
interrupts. To resolve this problem, select
a different interrupt for each PCI slot in the
PCI BIOS. To do this, enter the system
BIOS program; this is usually done by
pressing the DEL key when rebooting
your system. Once in the system BIOS,
enter the PCI/PnP BIOS setup, and select
a unique interrupt for each PCI slot. The
PCI BIOS assigns the interrupt; the device
on the PCI bus does not have control over
the interrupt assignment.
Some network devices do not share
interrupts. If you still have an interrupt
conflict, try removing the network device,
installing the DT3145 board and rebooting
the system, then reinserting the network
device.
The board is
damaged. Contact Data Translation for technical
support; refer to
page 46 .