DATA-LINC GROUP
18
PN 161-09990-002C
rev 3/29/04
SRM6200E-SLC User’s Guide
Main Menu Option (5): Edit Multi-Point Parameters
Figure 5: Multi-Point Parameters
Shown below are example settings. Please refer to supplied configuration sheets for your modem’s configuration.
In a multi-point network, it is critical to know how many radio modems are being used as repeaters. Any radio modem that is
used as a repeater essentially becomes a master to the Remotes and other repeaters to which it is communicating.
Therefore, the user must first identify how many repeaters are connected to the Master by assigning a value in parameter
(0) Number Repeaters. This parameter must also be set for each repeater in the system (i.e., in the event that a repeater is
connected to one or more other repeaters). This parameter does need to be set for multi-point remotes.
In point-to-point operation, the SRM6200E-SLC radio modems acknowledge every data packet transmitted. In a multi-point
network, the Remotes do not acknowledge transmissions from master to remotes. This is to prevent system overload. If the
Remotes acknowledged all data transmissions from the Master in a large multi-point system, then all system capacity would
be spent having the Master listen for acknowledgments from the Remotes. Because the transmission is not acknowledged
by the Remotes, 100% confidence does not exist that every remote has received every message from the Master. To
address this issue the user may modify option (1) Master Packet Repeat, assigning a value between 0 (the packet is
transmitted once) to 9 (the packet is repeated 9 times). For networks with solid RF links, this parameter would be set at the
lower end of the scale (0-1). If the network has some weak or marginal links it would be set toward the higher values. If a
remote receives a packet from a master more than once it will discard the repeated packets received.
While packets transmitted from the Master to the Remotes in a multi-point network are not acknowledged, packets
transmitted from remotes to the Master are acknowledged. However, it is possible that more than one remote will attempt to
transmit to the master at the same time, and it is therefore important that a protocol exists to resolve contention for the
Master between remotes.
This is addressed through parameters (2) Max Remote Retry and (3) Retry Odds. The Max Remote Retry setting defines
how many times (0 to 9) the Remote will attempt to retransmit a packet to the Master before beginning to use a back-off
algorithm. Once the Remote has unsuccessfully attempted to transmit the packet the number of times specified in Max
Remote Retry it will attempt to transmit to the master on a random basis.
