Data General AViiON 5500 Series, Установка, расширение и обслуживание

Страница: 49 / 192

Connecting synchronous devices
2-13
014–002250–01
Connecting synchronous devices
This section describes how to connect a synchronous device (such as
a modem) to the communications port labeled
SYNC
.
You’ll need one of the following male-to-male 25–pin cables and a
small, flat–blade screwdriver or similar tool:
Synchronous Devices
6–ft RS–232 cable
15–ft RS–232 cable
25–ft RS–232 cable
005–32917
005–32918
005–32919
15290E006
15290E015
15290E025
Cable or Cord Type Part Number Model Number
DB25 male to DB25 male
"
Complete the following steps to connect your device to the computer
unit rear panel. Reverse the order of these steps to remove or
replace the synchronous device.
1. Plug one end of the synchronous communication cable into the
SYNC
connector on the back of the computer unit, as shown in
Figure 2–9. Attach the cable to the connector by tightening the two
screws on the cable.
Computer Unit Rear Panel
Align and secure with screws
SYNC
Figure 2–9 Connecting a synchronous device to the computer unit
2. Plug the other end of the cable into the connector on the
synchronous device. See the documentation that came with the
device for further instructions.
IMPORTANT: To further set up your device to operate under the DG/UX operating
system, refer to Customizing the DG/UX

System.