Installation, Operation and Maintenance Manual
Page
iii
IMPORTANT SAFETY INSTRUCTIONS - SAVE THESE INSTRUCTIONS
Safety Alert Symbols and Words for Hazard Alerting Safety
DANGER
indicates a hazardous situation which, if not
avoided, will result in serious injury or death.
WARNING
indicates a hazardous situation which, if
not avoided, could result in serious injury or death.
CAUTION
indicates a hazardous situation which, if
not avoided, could result in minor or moderate
injury.
NOTICE
indicates information considered
important but may have potential hazard for
personal injury or property damage.
Special care
should be given to those areas where these symbols
appear.
During installation, operation, maintenance or service, individuals may be exposed to certain components or
conditions including, but not limited to: refrigerants, oils, and materials under pressure, rotating components, and
both high and low voltage. Each of these items has the potential, if misused or handled improperly, to cause bodily
injury or death. It is the obligation and responsibility of operating/service personnel to identify and recognize these
inherent hazards, protect themselves, and proceed safely in completing their tasks. Failure to comply with any of
these requirements could result in serious damage to the equipment and the property in which it is situated, as
well as severe personal injury or death to themselves and people at the site.
This document is intended for use by owner-authorized operating/service personnel. It is expected that this
individual possesses independent training that will enable them to perform their assigned tasks properly and safely.
It is essential that, prior to performing any task on this equipment, this individual shall have read and understood
this document and any referenced materials. This individual shall also be familiar with and comply with all applicable
governmental standards and regulations pertaining to the task in question.
This manual contains important safety instructions that should be followed during the installation and maintenance
of Data Aire equipment. Read this manual thoroughly before attempting to install or operate this unit.
Only qualified personnel should move, install or service this equipment. Adhere to all warnings, cautions and
installation, operating and safety instructions on the unit and in this manual. Follow all operating and user
instructions.
WARNING
Risk of electric shock can cause injury or death. Disconnect local and
remote electrical power before working within unit.
Customer must provide earth ground to unit, per NEC, CEC and local codes, as
applicable. Before proceeding with installation, read all instructions, verify that
all the parts are included and check the nameplate to be sure the voltage
matches available utility power.
