DASHCLEAN G12, Руководство по эксплуатации

Страница: 9 / 40

page- 9
Operating Manual G12/G18/G22/G32
2020 rev. 4.0
8. Electric safety

Improper connection of the equipment-grounding conductor can result in a risk
of electrical shock. Check with a qualified electrician or service person if you are
in doubt as to whether the outlet is properly grounded.

Do not modify the plug provided with the machine. If it will not fit the outlet, have
a proper outlet installed by a qualified electrician.

Before using the machine, make sure that the power & voltage corresponds with
the voltage shown on the machines rating plate.

Do not leave machine when plugged in. Unplug cord from outlet when not in
use and before cleaning or servicing machine.

Cables damaged through crushing or splitting can be dangerous if used and
should be replaced immediately. Risk of personal injury.

Do not use with damaged cord or plug. If the machine is not working as it should,
has been dropped, damaged, left outdoors or dropped in water. Make sure it is
repaired by a qualified person.
 Do not pull or carry by cord, use cord as handle, close a door on cord, or pull
cord around sharp edges or corners. Do not run the machine over cord. Keep
cord away from heated surfaces.
 Do not unplug by pulling on cord. To unplug, grasp the plug. Not the cord.

Do not handle plug or machine with wet hands.

Regularly inspect cord and plug for damage. If cord is damaged, it must be
replaced by a qualified person in order to avoid hazard.

Turn off all controls before unplugging.

If using an extension cord make sure the cord rating is suitable for this machine.

Connect to a properly grounded outlet only. See grounding instructions.
9. Thermal protection
The dust extractor is equipped with a safety thermal protector to prevent motor from
overheating. Should thermal protector activate, turn off machine, unplug power
cord and check for full dust bag, vacuum hose clog or filter blockage. It may take
up to 45 minutes for the thermal protector to reset.