DAS Smart DL-250, Руководство оператора

Страница: 16 / 18

15
In the Master Mode, the message displayed below means that all Areas are
secure and READY TO ARM. At this time, the green SECURE LED should be
illuminated.
SYSTEM READY
TYPE CODE TO ARM
In the Master Mode, the message displayed below means that AREAS 1, 2, 3,
and 4, are ARMED. At this time, the red ARMED LED should be illuminated.
AREA 1234
ARMED
To Arm or Disarm your system from the screens above, enter your four digit code.
A screen message similar to the one below will appear. This message will show
you what Areas the four digit code you entered has access to. In this case, your
code shows to be authorized in four Areas, so pressing the
[A] button (A=ALL
ON) will Arm Areas 1, 2, 3, and 4, or pressing the [D] button (D=ALL OFF) will
Disarm these Areas. If you press the [A] button and one of these Areas is not
ready, the screen will display the "AREA NOT READY", message followed the
zone status of that Area. To exit this screen, press the
[#] button..
SELECT AREA 1234
A=ALLON D=ALLOFF
From the screen above, you may choose to access just one particular Area. If so,
you would enter the number that corresponds to the Area that you wish to
access. Example: If you press
[1] , the screen below will appear noting the
codepad is accessing AREA #1.
AREA 1 OFF A=ON
C=CHECK B=NEXT
The preceding screen shows that AREA #1 is OFF (Disarmed). To Arm this Area,
simply press the
[A] button (A=ON). If AREA #1 had shown to be ON (Armed),
then D=OFF would have been displayed, meaning you would press [D] to turn
AREA #1 off(Disarm). At this time, the codepad sounder and LED's will refer to
Area #1 only.
Press the [C] button to enter the "CHECK" mode and the codepad will act as