8
PROGRAMMING ARM / DISARM CODES
Your security system can be armed and disarmed by the Master code (User Code #1) and up to
7 auxiliary codes. All codes must have 4 digits. These Auxiliary codes are individually
numbered from 2 to 7 (User code 7 may be reserved for an optional Duress code, see page 5
under "DURESS CODE"). If Auxiliary codes are desired, they must be programmed
individually. Only persons knowing the Master code can assign or change auxiliary codes (see
programming Auxiliary codes below).
CHANGING THE MASTER CODE - The master code is user code #1, and must be referred to
by its number. For example, if the Master code is [1]-[2]-[3]-[4] and you want to change it to [5]-
[3]-[4]-[2], the sequence would be as follows: Press [
]-[1]-[#] (this enters programming for user
#01), then [1]-[2]-[3]-[4] (the old Master code), then [
]-[1]-[#] , then [5]-[3]-[4]-[2] (new Master
code) then [
]-[1]-[#]. The entire sequence would consist of pressing the 17 keys shown below.
[
]-[1]-[#] - [1]-[2]-[3]-[4] - [
]-[1]-[#] - [5]-[3]-[4]-[2] - [
]-[1]-[#]
(Code 01) (Master Code) (New Code)
PROGRAMMING AUXILIARY CODES - In order to program Auxiliary Codes you must know
the Master code. As stated earlier, each auxiliary code has its own unique number from 2 to 15.
It is programmed much like the Master Code. For example, to program Auxiliary user code #12,
the sequence would be as follows:
[
]-[1]-[2]-[#] - [5]-[3]-[4]-[2] - [
]-[1]-[2]-[#] - [6]-[7]-[8]-[9] - [
]-[1]-[2][#]
(Code 12) (Master Code) (New Code)
REMOVING AUXILIARY CODES - To remove an Auxiliary user code, simply program that
code with the same code as the master code (01). For example, to remove user code #5, the
sequence would be as follows:
[
]-[1]-[2]-[#] - [5]-[3]-[4]-[2] - [
]-[1]-[2]-[#] - [5]-[3]-[4]-[2] - [
]-[1]-[2]-[#]
(Code 5) (Master Code) (Master Code)
USER PROGRAMMABLE TELEPHONE NUMBERS
When pager or siren tone formats are selected, any of the DL100's three phone numbers may
be programmed or altered in the run mode. The process would consist of entering the phone
number via the LED or LCD code pads with a read back facility only on the LED code pad.
The selection of Tone or Pulse dialing must be made via the normal programming methods,
therefore, the installer would program this selection during installation. You must use the
following procedure to enter and review your phone numbers.
PROGRAMMING PHONE NUMBERS
In the run mode and only while the DL100 is disarmed :
Press [
] [6] [1] [#] [MASTER CODE] [#]
(To enter the programming sequence for phone number one)
Press [
] [6] [2] [#] [MASTER CODE] [#]
(To enter the programming sequence for phone number two)
