Remember, setting higher gain does not change the maximum available power but changes the level of
signal input to achieve maximum power. In any case, provided that the input signal is less than 20dBu/7.7V,
the built in limiter circuit will prevent distortion within the amplifier.
The gain should be set to match the signal level from the source – mixer, equaliser etc.
Note: The gain of D-10 is fixed to 32dB. The gain of D-20 is 32dB (factory setting) or 36 dB by internal link.
E11EVEN SOUND \
D series amplifiers
\
User’s Manual
Parameter (Units)
D-100
D-10
D-20
8 ohms
1400
450
625
4 ohms
2800
750
1150
2 ohms
3700
1150
2100
8 ohms
5300
1500
2300
4 ohms
7400
2300
4200
Additional Specifications
THD+N:(%)(4 ohms)@1kHz (@1dB below max output power) <
0,08
0,008
0,008
THD+N:(%)(4 ohms)@20Hz to 20kHz (@3dB below max output power) <
0,15
0,03
0,03
Gain Options (dB):
26/32/36
32
32/36
Sensitivity Options (for maximum power) (dBu):
16/10/6
3,5
7.5/3.5
Sensitivity Options (for maximum power) (Volts):
4.9/2.5/1.5
1,2
1.8/1.2
Frequency Response - 20Hz to 20kHz (dB):
±0.5
+0 / -0.5
+0 / -0.5
Input Impedance - Active balanced (k ohms):
Input CMRR (dB):
Hum & Noise (dB below max output):
-105
-104
-106
Damping Factor: into 8 ohms:
Output Circuitry:
D
AB
AB
Power Consumption: Nominal @ 240v (4 ohms)(A):
7
1,9
2,8
Power Consumption: Nominal @ 120v (4 ohms)(A):
14
3,8
5,6
Dimensions (mm): H x W x D:
88x482x460
Dimensions (in): H x W x D:
3,5x19x18,2
Weight: (Kg):
12
13,8
20,42
Weight: (lb):
Output Power (per channel) (Watts) (Crest Factor of 4.8)
26,4
30,36
44,92
Output Power (bridged) ( Watts)
20
>60
>400 @1kHz
>200 @100Hz
3,5x19x16,9
88x482x428
SPECIFICATIONS
11
