Darex XPS-16+, Руководство по эксплуатации

Страница: 22 / 42

19
Wheel Offset Icon
Press this button to make minor wheel offset adjustments. This function might be
needed to compensate for new or different grit wheels.
1.
Load the factory file DAREX FILE
onto the main operating screen.
2. Measure the length of a 3/8” drill
bit using calipers. Write down the
value.
3. Sharpen that drill using the DAREX
FILE.
4. Re-measure the 3/8” drill bit end-to-
end. Subtract this measurement from
first measurement to define amount
of material being removed. Target
range for material removal is .005”
to .010” for the DAREX FILE.
5. Adjust X
[+]
or
[-]
buttons to
optimize material removal into target
range.
6. Adjust Z
[+]
or
[-]
buttons to
optimize split to be on center.
7. Press the
[CHECK]
button to save and return to previous screen.
At Center Short of Center Past Center
Hone Offset Icon
The hone brush is consumed as it is
used. This screen allows the user to
adjust the position of the drill in both
the X and Z axis as it enters the hone.
Tip: Adjustments are made in 1/1000
of an inch. Normal offsets for the
Hone will require more units of
adjustment in order to see change.
Belt Change Icon
In the event a spindle drive belt is compromised, press the [BELT CHANGE] icon
to move the grind motor to a position to access the motor mount bolts and change
the belt. Once the grind motor reaches the access position, a warning screen [RE-
START MACHINE] icon will pop up.
1. Power off sharpener.
2. Unplug power cord.
3. Remove access panel from rear of XPS-16+ and Perform Belt Change
4. Re Start the machine and initialize
Safe Icon
Store up to 100 customized drill files permanently.
1. Press the [SAFE] button to save a customized drill file.
2. Within the Safe screen press the [DISC] button to save.
3. Within the Safe screen press the [FILE] button to retrieve the last 100 files saved.
4. With each Safe save, all previous files saved will be overwritten.