DAPAudio Sessionmix 12 DSP, Руководство пользователя

Страница: 14 / 21

12
43 / 45. MASTER Fader
These faders control respectively the Left and Right output
level.
44. ALT 3-4 Fader
The fader controls the ALT output level.
Please, make sure to close the fader of the corresponding
input channel or at least the MASTER controls before
connecting any audio signal sources. This will save yourself,
your audience, and your equipment from unnecessary stress
resulting from plug-in noise.
Fig.11
29. Phones
This control allows you to adjust the headphones’ volume.
Caution: Depending on the type of headphones connected
to the phones jack, the Powermix is capable of producing
very high output levels via the phones output. Therefore,
make sure to turn the control all the way down (minimum
setting) before connecting the headphones.
Listening to loud sound pressure levels over a longer period
of time leads to hearing damage!
30. Aux 1 send
With this control You can adjust the level of the aux send
output.
Fig. 12
31. Phantom Power LED
This LED indicates when the phantom power is switched on for the microphone inputs. After switching on
the mixer, the red LED should not light up. So both balanced and unbalanced microphones can be
connected. Unbalanced microphones may be damaged if the Phantom power is activated however
unbalanced microphones are rarely to be found these days.
32. Aux 2 FX 2 Send
You can adjust the aux or FX value to the aux send output.
33. LED VU Meter
34. Level Set LED
This LED lights if the solo mode switch is set to PFL.
35. Solo LED
This LED lights if a channel is set to solo.
36. Solo mode
This switch lets you assign the Solo bus either PFL or AFL.
37. POWER LED
The green power LED lights when the Sessionmix is turned on. If, after switching the device on, the LED
does not light, make sure that the mains plug is plugged in correctly. If the LED still doesn’t light up, please
contact your DAP Audio dealer.
38/ 39/ 40. Control Room Source select
Use to select Main (38), ALT3-4 (39) or 2TKIN (40) as source for the control Room outputs.