DAPAudio DSM-26, Руководство пользователя

Страница: 8 / 29

6
9)
Load button
Pressing the Load button allows you to enter the Load menu directly.
10)
System button
Pressing the System button gives you access to the system setup menu.
11)
Save button
Pressing the Save button will save your preset.
12)
Polarity button
Pressing the Polarity button allows you to enter the Polarity menu directly.
13)
Output LED indi mute switches
Indicates the output level. Make sure the Clip led does only light occasionally. The limit led will light if
the internal limiter is actually limiting the signal.
Pressing the mute/ edit button shortly will mute the corresponding input.
Pressing and holding the mute/ edit button lets you enter the edit mode. In edit mode you can adjust
the Gain, polarity, delay, EQ and crossover for each output channel separately by pressing the
gain(2) , polarity(12) , delay(8) , EQ(3) or X-over(4) button.
14)
USB port
Connecting your computer to this port allows you to edit and manage your presets, using the
supplied software.
Backside
15)
IEC Con Fuse
This connector is meant for the connection of the supplied main cord. Connect one end of the
power cord to the connector, the other end to the mains, then turn on the power switch to operate
the unit.
Note: Please make sure that the supply voltage matches the operation voltage before connecting
the unit to mains. Replace the fuse only with a fuse of same specification (T4A).
16)
Power switch
Do not supply power before the whole system is set up and connected properly. Make sure the
115/230V(17) switch is set to the proper voltage.
17)
115V/230V Switch
Before plugging in the power cord, make sure the 115/230V switch is set to the proper
voltage.
18)
Ground
Ground screw if a separate groundwire is needed.
19)
RS485 ports
RS485 com port for linking with your computer if you need very long cables (up to 1500m). You can
link up to 250 sets. You can order an (optional) USB to RS485 under article number D2071.
20)
Output Sockets
XLR male balanced output.
21)
XLR Input Sockets
XLR female balanced input.