Danube WED 10, Инструкция по установке, использованию и техническому обслуживанию

Страница: 64 / 105

20
Then the following phase begins, in this case the wash phase, as can be observed in the
following Figure:
P2:WHITES/COLOUREDS 60 ºC
Wash
Temperature: 60 ºC
Filling...
While the programme is running the next keys on the control panel may be pressed,
activating different functions in each case:
9
START key: the programme stops, it is paused. The screen displays the message:
P2:WHITES/COLOUREDS 60 ºC
Wash
Wash. mach. pause
START to continue
If you want the programme to continue, you must press the same key again. Then the
message on the screen changes, going back to the same one as before the pause.
If the programme is spinning, it is not possible to make a pause, therefore pressing the
START key will have no effect.
9
ADVANCE key: when pressing the ADVANCE key the programme goes directly to the next
block, undergoing a drainage process.
After a few seconds, the programme continues, starting the next phase, unless the phase
being carried out when ADVANCE was pushed was the last one, in which case the
programme will end.
If the ADVANCE key is pressed during spinning, while the drum is slowing down, the
screen will display the following message:
P2:WHITES/COLOUREDS 60 ºC
Spin 500 rpm
Slowing...
9
STOP key: on pressing this key we can consider the programme finished. The screen will
display the next message:
P2:WHITES/COLOUREDS 60 ºC
Wash
Temperature: 60 ºC
END OF A PROGRAMME?
To end the programme, press the ENT key; for the programme to continue, press the ESC
key.