27
0
4
5
8
9
3
•
V
e
rsi
o
n
2
.3
•
1
6
.0
3
.2
0
1
2
3.2 How to install power to the MTS 4-outdoor enclosure,
contin-
ued
Procedure,
continued
Step
Action
4
Route the mains supply cable as
shown on the illustration.
Here the cable duct is put back on
5
Connect the power by securing the
ground.
Terminate the ground cable by a 5
mm terminal ring.
Insert the terminal ring to the earth
stud located to the top right side of
the power distribution board. (Cover
not on).
Tighten the nut using a 8mm
wrench.
6a
If the generator switch option is cho-
sen go to step 6b.
If not continue:
Insert the N, L1, L2 and L3 to the
main circuit breaker located at the
top right side of the power distribu-
tion panel
Recommended tightening torque is
2Nm
6b
(OLD)
Only if generator switch is installed:
Insert the N, L1, L2 and L3 to the
generator switch located on location
P1.29 (mid top rail).
Connection to Mains grid starting
from right N (blue) followed by L1,L2
and L3,
The 4 wires left are connecting the
generator cable located in the plinth.
Recommended tightening torque
is 0,8Nm
Continued overleaf
