Dantherm Gulliver RG3, Инструкция по эксплуатации

Страница: 8 / 11

Oilburner
Type Gulliver RG3
Page 6 of 9
Adjustment
K:\framen\instrukt\Dantherm\RG\Engelsk\RG3\RG3.fm-I1-021108-DM/lbk
Accessibility to the nozzle:
Remove nozzle-holder assembly (1) after
loosing screws (2) and nut (3), remove the
small cables (4) from the control box, the
photoresistance (6).
Withdraw the small cables (4) from the
electrodes, remove the diffuser disc-hol-
der assembly from the nozzle-holder as-
sembly (1) after loosing screw (3, fig. 2).
Learn the diffuser disc-holder assembly
(1) on the nozzle-holder (2) and lock it by
screw (3).
For prospective adjustments of the eletro-
des assembly, loosen screw (4).
Combustion head setting:
It depends on the output of the burner
and is carried out by rotating clockwise
or counterclockwise the setting screw (5)
until the set-point marked on the regula-
ting rod (9) is level with the outside plane
of the nozzle-holder assembly (1).
In the sketch the combustion head is set
for an output of 2,25GPH at 12 bar.
The set-point 3 of the regulating rod(9) is
at the same level with the outside plane
of the nozzle-jolder assembly (1) as
shown in the schedule.
Air damper adjustment
To vary the setting adjust the screw (7)
after loosing the nut (8).
Fig. 1
Fig. 2