Dante tecnare DAV-4x500, Руководство по эксплуатации

Страница: 33 / 38

33
Device List
w w w . t e c n a r e . c o m DAV-4x500 Amplifier | rev.:1.1
DAV-4x500
As shown in the plot 49, the device information displayed on the target device management interfa-
ce can be selected in the device list at the top. The device management interface is divided into the following three
blocks:
i. Software information: Display the version number and date information of the upper and lower
computer of the current device.
ii. Device information: Display the device name, device group, and factory name information of
the current device.
iii. Device IP information: If the current device is connected with network information, the device’s IP ad-
dress, gateway, and MAC address will be displayed here. IP and gateway can enter new information and
click the OK button to save and restart the device network module. The newly entered network information
will take effect immediately.
7.3. Channel name management
Click “Device”-”Channels” in the menu bar of the main interface of the software, and the channel
name management interface will appear, Figure 50.
Fig. 50 Channel name management
As shown in the figure 50, after entering the new name of the channel in the corresponding channel, click the OK button to
save and update the name of the channel immediately
7.4. Channel Copy
Click “Device”-”Channel Copy” in the menu bar of the main interface of the software, and the channel
copy interface will appear, Figure 51.
As shown in the figure above, the channel copy is to select the
channel parameters of a source device and copy to the target channels of other
target devices. Input channels and output channels cannot be copied to each
other. The left is the corresponding channel, and the right is the copied parame-
ter. The “Input” and “Output” buttons at the top of the interface can switch the
type of channel copied.
Fig. 51 Channel copy
Please Note, The length of the channel name is limited to 5 English letters and numbers.