you have to do from the beginning.
C. Always remember your new combination immediately and check whether
your new combination has been programmed or not while the safe door is
still open.
CAUTION!
Never write down your safe combination code next to or on the
safe!
4. USING YOUR SAFE
To open the safe, enter your personal code and confirm by pressing the button
“
A
”. You will hear a beep and the green light will be on, then open the door
using the knob within 5 seconds.
If you or an intruder uses the incorrect group of numbers, it will not open. If the
incorrect combination is used 3 times consecutively, you must wait for 20
seconds before reattempting. If again the incorrect combination is selected 3
times, you must wait approximately 5 minutes before reattempting access.
5. BATTERY REPLACEMENT WARNING
If the batteries are low, the red light in the left of the front display will warn you
immediately. To test the batteries, just input your personal numbers to open the
door. If the batteries are low, the red light will be on. If nothing happens, it
means that the batteries are in order.
6. REPLACING THE BATTERIES
The safe requires 4 pieces
size “AA” (1.5V) batteries. Open the safe, remove
the battery cover plate “
Y
” (see picture 2) on the back of the door and replace
the 4 pieces old batteries. You must reprogram the code, read the above
“PROGRAMMING THE CODE”. Use of alkaline batteries is recommended.
7. OVERRIDE INSTRUCTION TO OPEN THE SAFE
For your convenience, we have engineered a manual override system for your
safe. If you forget or misplace your combination, remove the small central
rubber cover
“
Z
“ (see picture 1) between knob and keypad, insert the key into
the keyhole and turn it in a counter-clockwise direction, then turn the knob in a
clockwise direction towards the right. This will manually open your safe at any
time.
8. INSTALLING THE SAFE
To reduce the risk of theft of the safe, it can be secured to floor, wall or in a
cupboard. For your convenience, there are holes (diameter 8mm) both in the
bottom and on the back; therefore it can be fixed by the expansion bolts
supplied.
CAUTION!
The safe should be placed horizontally when installing the safe.
Содержание Steinhaus SFT-15ENP
Страница 7: ...1 Z 1 1 2 4 AA 1 5V Y 2 2 3 A 2 3 8...
Страница 8: ...15 4 A 5 3 20 3 5 5 6 4 AA 1 5V Y 2 7 Z 1 8 8...
