40634-1510
1 12
®
NOTE: You can store your Key # and your Serial
# on Stack-On’s SECURE web site –
www.stack-on.com under Customer Service.
Storing your Key # will provide instant access to
this important information should you ever lose
your keys.
Only you will have access to this information.
Instructions
Serial #:
PDS-1500-B
Tools Required:
Drill
Thin Bladed Flat Head Screwdriver
Phillips Screwdriver
10 mm Wrench
1/4” (7 mm) drill bit
Hardware Included:
(2) M6 x 15 mm (5/8” long) Screws
(2) M6 Nylock Nuts
Locate the batteries inside the safe. Open the
battery compartment on the back of the door by
pushing the tab in the direction of the arrow and
install the batteries.
GETTING STARTED
When you first receive your safe you will need to
open the door with the key in order to install the
batteries. Batteries are included and are located
inside the safe.
To open the door with the key, first remove the
lock cover from the front of the faceplate using a
thin bladed flathead screwdriver as shown. Insert
the key and turn clockwise. Hold the key in the
open position and turn the knob to the right to
open the door.
Lock Cover
IMPORTANT
Record the serial number from the tag on the door
front.
Keep keys in a secure place away from children.
DO NOT STORE KEYS INSIDE SAFE.
NOTE: This key has also been provided in case the
batteries run low. If you lose your key, you may
purchase a replacement key by referencing the serial
number located under the removable lock cover
plate. See section at the bottom of this instruction
regarding replacement keys.
NOTE: The reset button located on the inside
of the door, is covered with a removable cap.
When you use the reset button while recording
your fingerprint, remove the cap to access the
button. Use a pen tip to push the reset button.
Replace the cap securely over the reset button
after recording your fingerprint. Failure to do
so will compromise the safety and security of
the safe.
