Dante DNA2000 Series, Инструкция по установке и эксплуатации, Страница: 89 / 200

Please note:
NVR wire IP and the WIFI can be in the same IP segment. But these two values may not be
the same.
The WIFI AP reboot process may be slow. Sometimes it may result in wait time out.
If user wants to use WPS function please make sure: a) Current network camera is not in the
black/white list. b) The WIFI AP authentication mode shall be WPA2. c) Current WIFI added
channel is smaller than the NVR max connected network camera mount.
Tips
User can go to the main menu->Setting->Default, and then select remote device. Click Ok button
to restore WIFI AP. See Figure 5-94.
Figure 5-94
5.10.3
Network Test
In this interface, user can see network test and network load information.
5.10.3.1 Network Test
Network test interface is shown as in Figure 5-95.
Destination IP: Please input valid IPV4 address and domain name.
Test: Click it to test the connection with the destination IP address. The test results can
display average delay and packet loss rate and user can also view the network status as OK,
bad, no connection and etc.
Network Sniffer backup: Please insert USB2.0 device and click the Refresh button, user can
view the device on the following column. User can use the dropdown list to select peripheral
device. Click Browse button to select the snap path. The steps here are same as preview
backup operation.
User can view all connected network adapter names (including Ethernet, PPPoE, WIFI, and 3G),
user can click the button on the right panel to begin Sniffer. Click the grey stop button to
stop. Please note system may not Sniffer several network adapters at the same time.