Dannmar maxjax, Руководство пользователя

Страница: 14 / 36

Chalk line
Use the edge of the base plate to
line up the posts along the chalk line
Sport compacts
105 " - 115 " Typical
Mid size
110 " - 120 " Typical
Light duty / sport trucks
115 " - 120 " Typical
Full size trucks
120 " - 13
5
"
Typical
VISIT US ON THE WEB AT WWW.DANNMAR.COM 14
STEP 5
( SITE LAYOUT )
1.
Determine the location of where the lift will be installed based on the size of vehicles servicing. The
dimensions shown below are rough guidelines. "Dry-fit" the vehicles intended to be serviced in the bay
by refering the the ALI Lifting Point Guide for appropriate lift points before final column spacing.
2. Once a location is determined, use a carpenters chalk line to layout a grid for the post locations. Keep
all dimensions and squareness within 1/8 " or malfunctioning of the lift can occur.
3. After the post locations are properly marked, use a chalk or crayon to make an outline of the columns
on the floor at each location using the post base plates as a template.
4. Double check all dimensions and make sure that the layout is perfectly square.
Note: Wide or narrow installation is possible. The lift can be installed at a width that suits the vehicles you
will be raising. You may even choose to install additional anchors at varied column positions for adaptabil-
ity to multiple vehicle configurations.
Recommended bay dimensions 20' deep and 14' wide.