Dannmar DT-50, Инструкция по установке и эксплуатации

Страница: 40 / 84

DT-50 and DT-50A Tire Changer
40
P/N 5900260 — Rev. A1 — Dec. 2020
⚠
CAUTION Make sure the Blade is
not
touching the Rim. The Bead Breaker Mechanism uses
a great deal of force. The Rim could be damaged if the Blade pushes on it instead
of the side of the Tire.
Step on and hold down the Bead Breaker Foot Pedal.
The Blade pushes in, moving the Bead out of the Bead Seat and in towards the Drop Center of the
Tire.
When the Bead breaks, it frequently (but not always) makes a popping sound.
Release the Bead Breaker Foot Pedal when the Blade goes all the way in or the Bead is broken.
If the Blade does not fully break the Bead, adjust the Tire and/or the Blade a little bit toward or
away from the Rim and then step on and hold down the Bead Breaker Foot Pedal again.
It may take several attempts to fully break the Bead.
When the Bead is broken at the current location, rotate the Tire 180° and break the Bead at that
location.
Important
: Every Tire is different. With some Tires, the entire Bead on one side could be
broken with the first use of the Bead Breaker Blade. Other Tires could take multiple
attempts until the Bead is broken all of the way around the Tire.
When the Bead is completely broken all the way around on one side of the Tire, move the Tire out,
turn it around, and then break the Bead on the other side of the Tire.
Again, avoid breaking the Bead at the Tire Pressure Monitoring System (TPMS), you could damage
the sensor.
Important : It may take you two or three times to break the Bead at any one spot. Nevertheless,
keep going until you break the Bead all the way around the Tire and on both sides
of the Tire.
⚠
WARNING Do
not
proceed to demounting the Tire until the Bead is broken
all the way
around
the Tire and on
both sides
of the Tire.