Danley DNA SC48, Руководство пользователя

Страница: 28 / 44

28
A further parameter “
Min
” may also be available for more advanced applications. This allows the
increasing limiting action at lower frequencies to level-off below a certain frequency. In most
application, this would be left set to its default value of 5Hz.
Amplifier Gain
Expressed in dB, this is the gain of the amplifier which the output of the SC48 is feeding. This value
must be entered to allow the SC48 to correctly calibrate the thermal and excursion limiter for the
amplifier in use.
Routing
Outputs can be driven from any DSP input. This routing is the fundamental means by which Drive
Modules are created. Routing should always consume outputs consecutively alphabetically and
numerically. However, non-consecutive Drive Modules may be created using manual routing and
Recalling Components . See the drive module section of this user manual for more information.
AES3
AES3 outputs are switched in pairs from System Engineer or front panel. The limiter calibration for
AES3 outputs is 0dBFS = +20dBu.
Utility Pages
Screen Contrast
The Screen page in the “
UTILITY
” section
adjusts the contrast (and optimal viewing angle) of the
screen from 0-
100% in 1% increments using encoder “
A
”.
Stereo Linking
Stereo linking is available between DSP Drive Modules A & B and between C & D. Changing a
parameter in either of the stereo linked Drive Modules will change the other linked Drive Module.
Stereo linking is controlled by the STEREO
page in the “
UTILITY
” menu.
Note: Stereo linking will only work when the linked Drive Modules are of equal size.
Current Ethernet IP Address
This may be viewed in t
he “
IP Curr
” page of the “
UTILITY
” menu
. This value cannot be edited.
IP Mode
The Ethernet IP address may be automatic “
Auto
” or may be a fixed static value “
Static
” as
determined by the “IP Mode” page of the “
UTILITY
” menu.
WARNING
–
Do NOT use Static mode unless your IT system specifically requires it. Auto mode
should always be used where possible since in this mode, the SC48
can always be ‘discovered’ by
the System Engineer application. When in Static mode, the IP Address will flash on the Home
screen.
Also see Ethernet Configurations .
IP Static
This allows the Static Ethernet IP address to be adjusted by the three rotary encoders on the IP Static
page of the
“
UTILITY
” menu.
This will only have effect when in Static mode.